![]() ![]() 220 and 240 volt models utilize a two-way ON /OFF switch only. Switch to the “on” side that yields the lowest amount of residual hum or popping noise when the instrument is touched. NOTE: The above statement in reference to removing the ground pin is applicable only to 1 20 volt model productsĬenter position is “OFF.” Two “ON” positions are provided, one of which will properly ground the amplifier. Less noise and greatly reduced shock hazard exists when the unit is operated with the proper grounded receptacles. ![]() If it is necessary to use the amplifier without proper grounding facilities, suitable grounding adapters should be used. It is not advisable to remove the ground pin under any circumstances. Will not operate unless main input is connected.Ĭontrols the volume level of the enclosure.įor your safety, we have incorporated a 3-wire line (mains) cable on the back of the chassis with proper grounding facilities. Use to send line level signal to additional power amplifier (DAISY CHAIN). Use to connect line level signal to power amplifier. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |